How to pose a decorative sticker?

Here are some tips to help you ask these decorative stickers trendy, without creases or bubbles. How to apply a sticker on an object? For small objects, no particular difficulty: we take off the adhesive sheet of paper on which it is sold, and applied as is, with some delicacy and attention all the same, directly the object that you want to decorate. How to apply a sticker on a wall or furniture? The wall stickers include three elements: the sticker itself, which is the only thing that will remain on the wall after the installation is complete, the liner paper or white sticker located under the stage when you receive it, and finally the film transparent sticker is pasted on, and called the tape. To ask a large wall sticker, without bubbles or creases, just follow a few simple rules, and always move smoothly, without wanting to be too fast. The stickers are generally of good quality come with a squeegee, which must first be used to smooth the transparent film (tape) on the sticker to ensure that these two elements are firmly attached to each other. Then, at the edge that will form the top of the set, peel off the liner about 1cm wide, and cut it to get a sticky tape that will be used to place the sticker in the right place, before starting poses itself. So put the sticker in the desired location, it will hang together with the strip of tape 1 cm wide, on which you press firmly to ensure its grip against the wall. Then place one hand under the set, you can fold up to help you, and start off the liner from below, gradually. In doing so, use your other hand to smooth the tape on the wall As you peel off the liner, always from the center to one edge and the center to the other side. Continue to the bottom of the decor. That's it! Now just take off very gently the transparent film or tape, which covers the stick, and behold it. How to apply a sticker on a car? The surface of a car is rarely flat, so it would be difficult to use the same method for a vehicle to a wall, but fortunately, there is a great solution, possible because no one can wet a problem car, which is not the case for a wall in the house. So just to first separate the sticker liner and spray soapy water on the sticky side of the sticker before applying to the vehicle. It smooths its best hand first, and then we pass a squeegee to expel as much water as possible and well to adhere the sticker. We can even finish with a rag to remove as much water as possible and provide better smoothing. Then allowed to dry for at least one hour before removing the tape.